MATERIAL: lace.
YOU NEED: clue interfacing; 5 buttons.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM
ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM
ALLOWANCE IS NOT PROVIDED.
SEAM ALLOWANCE:
1 cm for all seams.
ATTENTION! Before sewing, print paper patterns and lay them out according to the linen width (from 90 to 150
cm) to find out how much material you need (do not forget about double and
symmetric details).
WHEN SEWING, BE CAREFUL WITH NOTCHES – THEY MUST BE COINCIDING!
CUTTING:
Fabric:
1. Front part
center – 2 details
2. Front part side - 2 details
3. Back part center - 1 detail
4. Back part side – 2 details
5. Collar - 2 details
6. Sleeve - 2 details
Clue interfacing: front band, outer collar.
INSTRUCTIONS:
1. Strengthen
one-piece áîðòà facings with clue interfacing.
2. Sew relieves into front and back parts.
3. Half-turn one-piece edge
facings into wrong side, then press. Fold facings, then turn into right sides and
sew on front part neckline edges between áîðòà edge and transverse notch.
Cut seam allowances to 5 mm width and make notches at seam ends. Oversew facings into wrong sides and stitch to lower edge
of the garment.
4. Sew shoulder seams.
5. Sew side seams.
6. Overstitch inner collar
with outer one, then press.
7. Turn front bands into wrong side. Oversew and press edges. Sew inner collar to the neckline,
fold the outer collar open edge under and topstitch along the inner collar
joining seam.
8. Sew sleeve seams.
9. Sew sleeves into armholes,
fitting caps.
10. Oversew
sleeve and garment hem allowances, then press into wrong side and topstitch
along the edge.
11. Work button holes into
right front part and sew buttons to left one.
OUR ADVICE: to trim figure
sleeves and garment hems, cut front part, back part and sleeve details without
hem allowances. Lay these details to scallop.