5330 BLOUSE WITH ASYMMETRICAL SHOULDER

YOU NEED: jersey.

IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM ALLOWANCE IS PROVIDED,

IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM ALLOWANCE IS NOT PROVIDED.

SEAM ALLOWANCE: 1 cm. for all seams, 2 cm. for garment/sleeve hem.

ATTENTION! Before sewing, print paper patterns and lay them out according to the linen width (from 90 to 150 cm) to find out how much material you need (do not forget about double and symmetric pieces).

WHEN SEWING, BE CAREFUL WITH NOTCHES – THEY MUST BE MATCHING!

CUTTING:

Fabric:

1. Back – 1 piece

2. Front – 1 piece

3. Right sleeve front – 1 piece

4. Right sleeve back – 1 piece

5. Left sleeve – 1 piece

6. Left sleeve coulisse – 1 piece

ADVICE: to prevent seam from stiffing, sew details with special (zig zag) stitch. To prevent hem from stiffing neaten it with overlock and then stitch using double needle. Do the same for all edges must stay elastic.

The above is not for industrial manufacturing.

INSTRUCTIONS:

1. Neaten the central edges of the right sleeve. Stitch them leaving a slit according to the notches. Press the seam open. Topstitch the seam allowances 0.7 cm away from the joining seam leaving a slit close to the lower notch for pulling tie in; stop stitching 2 cm before the end.

2. Pin the coulisse stripe to the sleeve wrong side according to the marks. Unfold the stripe lower end. Topstitch the stripe along the marking.

3. Make the ties.

4. Stitch the shoulder/side seams and neaten them. Press these seams backwards.

5. Stitch the sleeve inner seams and neaten them. Press the seams backward.

6. Stitch the sleeves to the armholes according to the notches.

7. Neaten the front/back neck edges, garment hem and sleeve hems. Fold the neatened edges to the wrong side and topstitch them. Insert the ties into the coulisses. Pull the ties ends gathering the fabric.