FABRIC: denim and a knitted material.
YOU NEED AS WELL: iron-on interfacing; 7
buttons; drawstring for the hood.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE
SEAM ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR,
THE SEAM ALLOWANCE IS NOT PROVIDED.
SEAM ALLOWANCE: 1 cm for all seams; 3cm for hem.
ATTENTION! Before sewing, print paper patterns and lay them out
according to the linen width (from 90 to 150 cm) to find out how much material
you need (do not forget about double and symmetric pieces).
WHEN SEWING, BE CAREFUL WITH NOTCHES – THEY MUST BE
MATCHING!
CUTTING:
Fabric:
1. Back Yoke – 1
piece
2. Back neck facing –
1 piece
3. Side front – 2
pieces
4. Front Yoke – 2
pieces
5. Middle front – 2 pieces
6. Centre front – 2
pieces
7. Front facing – 2
pieces
8. Flap – 4 pieces
1. Back – 1 piece
2. Sleeve – 2 pieces
3. Centre hood – 1
piece
4. Hood – 2 pieces
5. Cuff – 2 pieces
Interfacing: facings.
INSTRUCTIONS:
1. Apply the interfacing
to the wrong side of the facings.
2. Stitch the curved
edges of the side/middle front. Neaten and press these seams towards the center.
Stitch the curved edges of the centre/middle front. Neaten and press them
towards the center. Make double decorative stitch 0.2cm away from the
seamlines.
3. Stitch the back
yoke to the back piece. Neaten this seam and topstitch 0.2cm above the
seamline.
4. Stitch the flap
pieces together right sides inside. Trim the seam allowances on the corners and
turn the flaps inside out. Edgestitch them 0.5cm in.
5. Place the flap to
the front yoke lower edge and stitch according to the marks. Stitch the yoke to
the front piece. Neaten this seam and topstitch to the yoke with double
decorative stitch 0.2 cm above.
6. Neaten the outer
edge of the front/neck facing. Stitch the front facings to the front pieces.
Turn the edging inside out and edgestitch with double decorative stitch 0.2cm in
from the edges. Joining the front/back facings across the shoulder seams.
7. Stitch the
side/shoulder seams. Neaten and press them backward.
8. Stitch and neaten
the hood pieces. Neaten the front raw edge of the hood, mark and make
buttonholes. Fold this edge inside and topstitch. Stitch the hood to the
neckline. Overstitch the neckline with the facing. Fix the outer edges of the
front facings to the shoulder seams.
9. Stitch the side
edges of the cuffs. Stitch and neaten the sleeve seams. Fold the cuffs along
the length and stitch to the sleeve lower edges.
10. Stitch the
sleeves to the garment according to the notches.
11. Make buttonholes
in the right front piece; sew buttons on the left piece. Pull the drawstring
into the hood through the buttonholes.