YOU NEED: natural fabric, fusing,
zipper.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM
ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM ALLOWANCE
IS NOT PROVIDED.
SEAM ALLOWANCE: 1 cm for all seams, 6 cm for hem.
ATTENTION! Before sewing, print paper patterns and lay them out according to the linen width (from 90 to 150
cm) to find out how much material you need (do not forget about double and
symmetric details).
WHEN SEWING, BE
CAREFUL WITH NOTCHES – THEY MUST BE COINCIDING!
CUTTING:
Fabric:
1. Belt
loop – 1 piece
2. Back
panel – 1 piece
3. Front
panel – 1 piece
4. Back
yoke – 2 pieces
5. Front
yoke – 2 pieces
Fusing: front
yoke, back yoke.
INSTRUCTIONS:
1. Apply
the fusing to wrong side of front yoke and back yoke.
2. Make
pleats into front panel and back panel stitching pleats to notch.
3. Sew
front yoke to front panel. Press joining seam towards the yoke.
4. Sew back
yoke to back panel. Press joining seam into yoke.
5. Neaten
side edges. Sew side seam of front/back panels, leaving a slit for zipper in
left side seam. Press side seams apart and press closure slits. Sew the zipper
in.
6. Sew
side right seam reinforced with fusing front yoke and back yoke. Press joining
seam apart. Neaten yoke outer edge.
7. Fold
yokes with garment upper edge, right sides together, and overstitch. Topstitch
overstitch seam on strengthened yokes at 0.2 cm from overstitching. Turn yokes
into wrong side and press garment upper ready edge. Sew turned under side edges
of front and back yokes to zipper braids. Topstitch yoke neatened edge to
joining seam.
8. Fold belt loop along the center right side inside,
coincide edges and overstitch at 0.5-0.7 cm from edges. Turn the loop right
side out, place the seam at bending of make edging of 0.1-0.2 cm width into
wrong side, then press. Cut belt loops and topstitch them on yokes.
9. Neaten
font/back panels hem, press it under and sew by hand.