YOU NEED: sheer flax; fusing; 1 zipper; 10
buttons.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM
ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM
ALLOWANCE IS NOT PROVIDED.
SEAM ALLOWANCE: 1 cm for all seams, 2 cm for hem.
ATTENTION! Before sewing, print paper patterns and lay them out according to the linen width (from 90 to 150
cm) to find out how much material you need (do not forget about double and
symmetric details).
WHEN SEWING, BE
CAREFUL WITH NOTCHES – THEY MUST BE COINCIDING!
CUTTING:
Fabric:
1. Front part
– 2 pieces
2. Back part
– 2 pieces
3. Front facing – 2 pieces
4. Back facing – 2 pieces
5. Fly panel facing – 1 piece
6. Inner front part – 4 pieces
Fusing: front facing, back facing, fly panel facing, inner
front part, fusing stripe.
Fusing
stripe must be of 4 cm width and of 2-3 cm longer than pocket entrance.
INSTRUCTIONS:
1. Apply the fusing to wrong side of
back/front facings, fly panel facing and inner front part.
2. Mark
slit place on front panel and reinforce it with fusing stripe.
3. Sew back darts and press them towards back center.
4. Neaten inside
leg/side edges, front/back middle edges.
5. Press
side edge of fly panel facing along marked line. Neaten curve edge of fly panel
facing.
6. Lay
details of inner front part together. Overstitch middle front edge and curve
edge of inner front part. Turn inner front part and press it.
7. Stitch
pressed fly panel facing to marked slit line on front part. Lay Stitch front
inner part to slit line on another side. Control stitching: stitches must be
parallel, their ends must be at the same level; distance between stitches must
be equal to width of off-set welt (made of ready fly facing). Cut front part
along the center, between stitches. Make diagonal notches at 1-1.5 cm from stitch end. Pull inner front part and
fly panel facing right side out through this slit. Fix slit ends with double
reverse stitches along corner bases on wrong side. Neaten lower edge of fly
panel facing and of inner front part.
8. Sew
inside leg/side seams and press the apart. Sew inside leg seam and inside leg seam.
Make another stitch close to inside leg seam.
9. Sew
front/back facings side seams. Press
facing side seams apart.
10.
Overstitch front part upper edge with fly panel facing. Make decorative stitch
along upper contour/curved contour of fly panel facing at 0.2 cm from edge.
11. Neaten lower
facings outer edges. Stitch facings to upper part of inner front part and back
part upper edge coinciding side seams. Overstitch facing corners. Slash corner
allowances, turn them right side out and press. Topstitch neatened facing edge
along joining seam.
12. Make buttonholes into front part. Sew buttons on inner front part.
13. Neaten garment hem. Press the hem under and
topstitch. Make buttons into front facing right edge. Sew buttons on front facing left edge.