YOU NEED: natural/mixed fabric, zipper.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM
ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM
ALLOWANCE IS NOT PROVIDED.
SEAM ALLOWANCE: 1 cm for all seams, 2 cm for garment
hem.
ATTENTION! Before sewing, print paper patterns and lay them out
according to the linen width (from 90 to 150 cm) to find out how much material
you need (do not forget about double and symmetric details).
WHEN SEWING, BE
CAREFUL WITH NOTCHES – THEY MUST BE COINCIDING!
CUTTING:
Fabric:
1. Back part – 2 pieces
2. Side part – 2 pieces
3. Drapery – 4 pieces
4. Front part – 1 piece
Lining:
1. Back part – 2 pieces
2. Side part – 2 pieces
3. Front part – 1 piece
INSTRUCTIONS:
Our advice: specify drapery during fitting.
1. Stitch side darts, press them backwards.
2. Neaten
lower/upper edges of drapery. Press upper edge of drapery into wrong side at
0.5 cm from edge. stitch lower edge of drapery to notch, press joining seam
apart pressing slits. Make decorative stitch along slits at 0.5 cm from edge.
Make pleats into drapery yourself or by ready draped fabric. Specify the
drapery according to pattern and interlace the drapery according to technical
sketch; tack the drapery to front relief edge.
3. Neaten
front/back relieve seams, stitch them and press apart; leave a slit into d\font
left relieve seam.
4. Neaten
middle back edge. Stitch middle seam up to closure notch, press the seam apart
pressing closure slits. Stitch the zipper in.
5. Stitch
lining detail leaving a slit into font left relief seam. Neaten lining seams
and press front seams towards front center and back seams press towards back
center. Neaten lining middle edge. Neaten lining hem, fold it under and
topstitch.
6. Cut shoulder straps. Fold shoulder straps along the center wrong side
out and make a stitch at 0.5 cm from fold. Turn straps tight side out and press
them. Sew straps to front neckline.
7. try the dress, adjust
strap length and sew back seams on back part.
8. Tack
drapery to edge of front armhole and process the draping. Overstitch front/back
neckline, armhole and a slit into relieve seam with the lining. Topstitch
overstitching allowance on the lining at 0.2 cm from overstitching. Remove tacking. Fold lining’s middle edge under and
stitch it to dress allowance at closure segment. Make decorative stitch along
the slit at 0.5 cm from edge.
9. Neaten
dress hem, fold it under and topstitch at 1.5 cm from lower edge.