YOU NEED: sheer
natural/mixed fabric.
IF THE PATTERNS
HAVE DOUBLE CONTOUR, THE SEAM ALLOWANCE IS PROVIDED,
IF THE PATTERNS
HAVE SINGLE CONTOUR, THE SEAM ALLOWANCE IS NOT PROVIDED.
SEAM ALLOWANCES: 1 cm for all seams, 0 cm
for front/back necklines.
ATTENTION! Before sewing, print paper patterns and lay them out according to the linen width (from 90 to 150
cm) to find out how much material you need (do not forget about double and
symmetric details).
WHEN SEWING, BE
CAREFUL WITH NOTCHES – THEY MUST BE COINCIDING!
CUTTING:
Fabric:
1. Back
part – 1 piece
2. Front
part – 1 piece
3. Placket – 2 pieces
INSTRUCTIONS:
1. Stitch right shoulder edge. Press the seam backward and neaten it.
2. Cut a piping of 4 cm width and of length equal to front/back neckline
length. Fold the piping along the center right side out. Lay it flat and press
long edges to marked middle line. Trim neckline with the piping.
3. Stitch left shoulder edges. Press the seam backward and neaten it.
4. Neaten lower edges, press the into wrong side
and topstitch.
5. Press placket’s short edges into wrong side and topstitch. Press
placket’s long edges into wrong side. Lay the placket on front part as marked
and topstitch at 0.1 cm from bending.
6. Cut 2 ties of necessary length and of 10 cm width. Fold ties along
the center wrong side out, then overstitch along one
long/one short edges. Turn ties right side out, press them. Fold raw allowances
under and topstitch at 0.1 cm from edges. Pull ties into plackets.