YOU NEED: faux sheepskin; lather braid; 1 separable zipper; 2 zippers for sleeves.
IF THE PATTERNS
HAVE DOUBLE CONTOUR, THE SEAM ALLOWANCE IS PROVIDED,
IF THE PATTERNS
HAVE SINGLE CONTOUR, THE SEAM ALLOWANCE IS NOT PROVIDED.
ATTENTION! Before sewing, print paper patterns and lay them out
according to the linen width (from 90 to 150 cm) to find out how much material
you need (do not forget about double and symmetric details).
WHEN SEWING, BE
CAREFUL WITH NOTCHES – THEY MUST BE COINCIDING!
CUTTING:
Faux fur:
1. Upper back part – 2 pieces
2. Lower back part – 1 piece
3. Front
yoke – 2 pieces
4. Middle
front part – 2 pieces
5. Lower
front part – 2 pieces
6. Upper
sleeve – 2 pieces
7. Lower
sleeve – 2 pieces
8. Back
collar – 1 piece
9. Front
collar – 1 piece
INSTRUCTIONS:
1. Stitch middle back edges.
Stitch lower back part to upper back part.
2. Stitch front yoke to
middle front part. Stitch lower front part to middle front part.
3. Stitch shoulder edges.
4. Stitch collar’s shoulder
edges. Stitch the collar into the neckline.
5.
Separate the zipper, fold braids’ upper corners under. Lay the zipper on front
part/collar right sides together; zipper teeth align with marked seams (zipper
braid is on the allowance), then tack. Fold leather braid’s short edges into
wrong side, pin it to front part right sides together, then stitch catching
zipper braids. Fold the zipper into wrong side, fold long edge under and
topstitch it at 0.7 cm from front edging and along braid edge.
6. Stitch side edges.
7. Stitch upper/lower
sleeves together. Stitch sleeve seam to the mark. Fold slit allowances into
wrong side, lay the zipper under them, fold braids’ ends and topstitch. Stitch
sleeves into armholes as marked.