You need: sheer
natural/mixed fabrics; lining, fusing, wide inkle (see approximate length on
sleeve pattern), clasp.
IF THE PATTERNS HAVE DOUBLE CONTOUR, THE SEAM
ALLOWANCE IS PROVIDED,
IF THE PATTERNS HAVE SINGLE CONTOUR, THE SEAM
ALLOWANCE IS NOT PROVIDED.
SEAM ALLOWANCES: 1 cm for
all seams.
ATTENTION! Before sewing, print paper patterns and lay them out
according to the linen width (from 90 to 150 cm) to find out how much material
you need (do not forget about double and symmetric details).
WHEN SEWING, BE CAREFUL WITH NOTCHES THEY MUST BE
COINCIDING!
CUTTING:
Fabric:
1. Back part 2
pieces
2. Front part 2
pieces
3. Sleeve 2 pieces
4. Front band 2
pieces
5. Back neckline
facing 2 pieces
Lining:
1. Back part- 2
pieces
2. Front part 2
pieces
3. Sleeve 2 pieces
Fusing:
1. Front band 2
pieces
2. Back neckline
facing 2 pieces
NB: when
cutting lining front/back pieces, do not take into account front
bands/back neckline facing widths correspondingly.
INSTRUCTIONS:
1. Apply the fusing to
wrong side of front bands and back neckline facing.
2. Stitch back middle
edge. Slash rounded allowances and press them apart.
3. Stitch shoulder
edges. Slash rounded allowances and press them apart.
4. Stitch sleeves to
front/back parts. Press seam allowances toward sleeves.
5. Stitch middle of
back neckline facing. Press seam allowances apart. Stitch shoulder edges of
front bands and facings. Press seam allowances apart.
Stitch lining pieces
together leaving a hole into sleeve right front seam (to turn the garment right
side out).
Stitch the lining to
front bands and back neckline facing.
Lay front bands with
the lining on the garment right sides together and overstitch around along
front edging/neckline/hem.
Slash rounded
allowances, cut corners, turn the garment right side out, then press.
Sew technological hole.
6. Cut four fabric
quadrates of 4x9 cm. Apply the fusing, neaten along perimeter. Lay them on slit
marking right sides together, then stitch along marking. Slit the fabric
between stitches as for slit pocket. Make diagonal slashes at 1-1.5 cm from
short edges. Turn the facing into wrong side trough this hole. Make decorative/fixing
stitch along edges of this hole.
7. Topstitch the
inkle along lapel edges/front edgings, garment/sleeve hems.
8. Fold the waistband
along the center wrong side out, overstitch along thee edges leaving a hole
into waistband upper seam. Cut seam allowances in corners, turn the waistband
right side out, stitch the hole. Pull the waistband into clasp and fix it. Set eyelets.
Our advice: you can
use ready belt as a waistband.